Rcm solder repair question
Rcm solder repair question
I recently had my mechanic friend perform the solder repair on the RCM. The posts were showing through the original solder and my crossfire would only start in a.m., once the outside temp rose I could not start.
My question is after we re soldered he test the connections with a volt meter. On the "A" points 2 and 3 have continuity even though we can not see any solder touching. Are these two connections supposed to have continuity? I don't want to re install the rcm and burn something else up. Forgive my ignorance.
My question is after we re soldered he test the connections with a volt meter. On the "A" points 2 and 3 have continuity even though we can not see any solder touching. Are these two connections supposed to have continuity? I don't want to re install the rcm and burn something else up. Forgive my ignorance.
Thread
Thread Starter
Forum
Replies
Last Post
KDW4Him
Troubleshooting & Technical Questions & Modifications
18
09-01-2021 05:47 PM
northwest_crossfire
Troubleshooting & Technical Questions & Modifications
9
05-30-2016 05:19 PM
unarel32
Troubleshooting & Technical Questions & Modifications
35
10-06-2015 05:53 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)