Need clarification on checking fluid level of automatic transmission

Reply Subscribe

Thread Tools

#1 (permalink)

04-20-2015, 06:12 PM

IBLUBYU

Senior Member

Thread Starter

Join Date: Mar 2010

Location: Sun City West, AZ

Posts: 1,363

Likes: 0

Received 0 Likes on 0 Posts

Need clarification on checking fluid level of automatic transmission

When checking automatic transmission fluid level, with engine running and at proper temperature (assuming), should reading on the dipstick, be with transmission in PARK, NEUTRAL, or IN GEAR. Maybe it doesn't matter if that's the correct way, but I'd like to know the way it's supposed to be. Thanks in advance.....

Last edited by IBLUBYU; 04-20-2015 at 07:52 PM.

Reply Like

#2 (permalink)

04-20-2015, 10:35 PM

KDW4Him

Senior Member

Join Date: Nov 2011

Location: Alma, MI

Posts: 1,276

Likes: 52

Received 23 Likes on 16 Posts

Re: Need clarification on checking fluid level of automatic transmission

From the manual.....

4. Actuate the parking brake. Start engine and let it run at idle speed in selector lever position “P”.
5. Shift through the transmission modes several times with the vehicle stationary and the engine idling
6. Warm up the transmission, wait at least 2 minutes and check the oil level with the engine running. Push the Special Tool 8863A (1) in up to the stop and pull out again, read off oil level, repeat if necessary.
7. Check the transmission oil temperature. NEED THE DRBIII SCAN TOOL TO KNOW THE EXACT TEMP
Note: The true transmission oil temperature can only be read by a scan tool in REVERSE or any forward gear position.
8. The transmission Special Tool 8863A has indicator marks every 10mm. Determine the height of the oil level on the dipstick and using the height, the transmission temperature, and the Transmission Fluid Graph, determine if the transmission oil level is correct.
9. Add or remove oil as necessary and recheck the oil level.