Lowest Aftermarket Springs?
Lowest Aftermarket Springs?
Okay, so after searching here and online, I'm not finding a definite answer to my question, which spring will drop my crossfire the most? Getting the camber bars from Ground Control and the camber bolts for the front so I am good to go (Or at least I hope!) on that front. I really don't care how low the car sits, I just want to get ride of the 2 inch wheel well gap in there rear.
Also while I am asking questions, can some one shed some light on the spring pads? in the past on cars that I have lowered, I have taken these out completely sometimes and would slide a piece of rubber hose on the last coil to keep the noise down. I seen a variety of pad sizes on needswings.com, if I want the lowest drop possible do I just order the thinnest pads? or would the rubber hose trick work?
Thanks in advance.
Also while I am asking questions, can some one shed some light on the spring pads? in the past on cars that I have lowered, I have taken these out completely sometimes and would slide a piece of rubber hose on the last coil to keep the noise down. I seen a variety of pad sizes on needswings.com, if I want the lowest drop possible do I just order the thinnest pads? or would the rubber hose trick work?
Thanks in advance.
Join Date: Jul 2011
Location: Barrhaven, Ontario
Age: 60
Posts: 914
Likes: 0
Received 3 Likes
on
3 Posts
Re: Lowest Aftermarked Springs?
I would recommend that you cut your springs by 1/4 of a circle at a time and no more than 1/2 a circle. This will give you aprox. 1.5" drop. Any more than that and the ride becomes too harsh and unplaisant. If you want to drop more and are on a budget, you can shave the pillow blocks. I like the slipping a hose over the coil spring idea. However, I doubt this would be a long term solution
Join Date: Sep 2007
Location: MOFN, AL, 70 miles from George
Age: 66
Posts: 8,017
Likes: 0
Received 7 Likes
on
7 Posts
Join Date: Sep 2007
Location: MOFN, AL, 70 miles from George
Age: 66
Posts: 8,017
Likes: 0
Received 7 Likes
on
7 Posts
Re: Lowest Aftermarked Springs?
I'm on slightly tweaked KW V2 coilovers. They don't normally go this low....lol. And for the love of god don't cut your springs. It's not an 80's Honda.
FB_IMG_1433901575241_zpsmifxqio0.jpg
FB_IMG_1433901575241_zpsmifxqio0.jpg
Join Date: Sep 2007
Location: MOFN, AL, 70 miles from George
Age: 66
Posts: 8,017
Likes: 0
Received 7 Likes
on
7 Posts
Re: Lowest Aftermarked Springs?
How long would you say 'break-in' takes? I've just purchased some -35mm springs and had them fitted and it hasn't lowered the car as much as I thought it would...
Thread
Thread Starter
Forum
Replies
Last Post
Blackktieguy
Engine, Exhaust, Transmission and Differential
21
10-26-2015 12:32 AM
2005 Ragtop
Wheels, Brakes, Tires and Suspension
7
10-03-2015 03:01 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)