Running starting and running problems the car will start twice and run for 2 seconds
Thread Starter
Joined: Aug 2022
Posts: 1
Likes: 0
From: Buffalo new york.
Running starting and running problems the car will start twice and run for 2 seconds
Hi everyone the car will start twice and run for 2 seconds and then dies on the third time it'll start and run if I turn the key off it won't start then I have to unhook the battery and wait 20 minutes when it starts it runs fine any ideas thanks
Joined: May 2018
Posts: 217
Likes: 108
From: Woodstock Ontario CANADA
Re: Running starting and running problems the car will start twice and run for 2 seco
https://www.needswings.com/crossfire-skreem-repair
https://www.crossfireforum.org/forum...ps-skreem.html
https://www.crossfireforum.org/forum...s-repairs.html
https://www.crossfireforum.org/forum...ps-skreem.html
https://www.crossfireforum.org/forum...s-repairs.html
Joined: May 2018
Posts: 217
Likes: 108
From: Woodstock Ontario CANADA
Re: Running starting and running problems the car will start twice and run for 2 seco
Thanks AMX1397.
I forgot the basics and how many problems the RCM can cause. It should be looked at first.
I forgot the basics and how many problems the RCM can cause. It should be looked at first.
Administrator
Joined: Jun 2009
Posts: 13,964
Likes: 1,290
From: Fort Worth, Texas
Re: Running starting and running problems the car will start twice and run for 2 seco
The SKREEM is powered from pin 3 of the ignition switch, not the RCM. IF you are getting three cranks then nothing, the RCM is powering up the ECU, therefore, the RCM is not the issue.
One of the following is your problem:
1) You changed key fobs and forgot to transplant the little black RFID chip to the new fob. (You'd know if it you did.)
2) You messed with the dash and either damaged the black ring around the key or accidentally yanked the wires from the ring to the SKREEM out of the SKREEM. (You'd know it if you did.)
3) Your SKREEM has failed. (OFTEN happens.)
4) Your ECU has failed. (NEVER happens.)
Senior Member
Joined: Apr 2008
Posts: 6,713
Likes: 453
From: Indialantic Fl./blairsville Ga
Re: Running starting and running problems the car will start twice and run for 2 seco
Jim is the nicest, best guy on the forum, but I disagree.
The SKREEM is powered from pin 3 of the ignition switch, not the RCM. IF you are getting three cranks then nothing, the RCM is powering up the ECU, therefore, the RCM is not the issue. thanks pizzaguy you are the best.
One of the following is your problem:
1) You changed key fobs and forgot to transplant the little black RFID chip to the new fob. (You'd know if it you did.)
2) You messed with the dash and either damaged the black ring around the key or accidentally yanked the wires from the ring to the SKREEM out of the SKREEM. (You'd know it if you did.)
3) Your SKREEM has failed. (OFTEN happens.)
4) Your ECU has failed. (NEVER happens.)
The SKREEM is powered from pin 3 of the ignition switch, not the RCM. IF you are getting three cranks then nothing, the RCM is powering up the ECU, therefore, the RCM is not the issue. thanks pizzaguy you are the best.
One of the following is your problem:
1) You changed key fobs and forgot to transplant the little black RFID chip to the new fob. (You'd know if it you did.)
2) You messed with the dash and either damaged the black ring around the key or accidentally yanked the wires from the ring to the SKREEM out of the SKREEM. (You'd know it if you did.)
3) Your SKREEM has failed. (OFTEN happens.)
4) Your ECU has failed. (NEVER happens.)
but when i had that problem i disconnect my batt ,pumped the brake a few times to discharge the system. let my car sit with batt disconnected for about 20 minutes ,fired it up drove home then swapped the rcm,,,no more no start. no problems the only difference i was in My V8 crossfire.
Last edited by amx1397; Aug 24, 2022 at 06:17 PM.
Thread
Thread Starter
Forum
Replies
Last Post
MARTHA64
Troubleshooting & Technical Questions & Modifications
3
Sep 1, 2018 04:44 PM
nid4u
Troubleshooting & Technical Questions & Modifications
4
Sep 1, 2014 04:27 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
