CrossfireForum - The Chrysler Crossfire and SRT6 Resource

CrossfireForum - The Chrysler Crossfire and SRT6 Resource (https://www.crossfireforum.org/forum/)
-   Crossfire Roadster (https://www.crossfireforum.org/forum/crossfire-roadster/)
-   -   At my wits end!! (https://www.crossfireforum.org/forum/crossfire-roadster/78928-my-wits-end.html)

8ighth Wonder 09-09-2018 03:52 AM

At my wits end!!
 
My crossfire has again started acting weird!!
The symptoms are random and as follows:
1) All dash lights on while driving, at times the shift position indicator reads "P" while in D. When this happens the car is struggling to reach 30mph
2)Coolant, oil, Check engine and BAS flicker while driving.
3) Sometimes it starts after disconnecting the battery, sometimes it does a partial crank then nothing.
No codes present at the time.

RCM has been modded bu DJ, Batt and alternator are new and have been checked. Voltages are stable.

ala_xfire 09-09-2018 07:15 AM

Re: At my wits emd!!
 
Sounds like a flaky ground connection, battery to frame, or engine to frame.

8ighth Wonder 09-09-2018 07:17 AM

Re: At my wits emd!!
 

Originally Posted by ala_xfire (Post 911923)
Sounds like a flaky ground connection, battery to frame, or engine to frame.

battery to frame is good not really a voltage drop there. Where is the engine to frame connection?

8ighth Wonder 09-09-2018 07:26 AM

Re: At my wits emd!!
 

Originally Posted by ala_xfire (Post 911923)
Sounds like a flaky ground connection, battery to frame, or engine to frame.

Upon researching it seems ill have to add one. I had an issue like this before on a RADAR. I'll give it a shot.

8ighth Wonder 09-09-2018 07:42 AM

Re: At my wits emd!!
 
Let me add, no problems starting it now that it's cooked off

ala_xfire 09-09-2018 07:50 AM

Re: At my wits emd!!
 

Originally Posted by 8ighth Wonder (Post 911924)
battery to frame is good not really a voltage drop there. Where is the engine to frame connection?

Driver side, bare copper mesh wire.

8ighth Wonder 09-09-2018 02:20 PM

Re: At my wits emd!!
 

Originally Posted by ala_xfire (Post 911927)
Driver side, bare copper mesh wire.

Did a chat with DJ very informative, I learned a lot about the RCM. Led me back tui the CPS. When I push the wire towards the front of the vehicle it runs fine. When I push it thi the back it dies or the lights all come on, fan speeds up, etc. Going to replace the sensor first as it's not a Bosch.

ZERACER 09-09-2018 03:49 PM

Re: At my wits end!!
 
Please let everyone know the outcome.

8ighth Wonder 09-09-2018 10:00 PM

Re: At my wits end!!
 

Originally Posted by ZERACER (Post 911935)
Please let everyone know the outcome.

Changed the CPS; A CPS code, trans range code and serial data link code popped up. I drove it for an hour all codes cleared. It's looking good so far.


All times are GMT -4. The time now is 04:41 PM.


© 2024 MH Sub I, LLC dba Internet Brands