many have stated there is not a diagram for the serpentine belt ... therefore i have created a decal that can be referenced easily for a replacement belt install.







~ cost including shipping would be $10.

please send me a personal message (pm) for ordering info.

my email is: handwaxone@gmail.com

 

Andrew, $ sent! Check your PP!

Thanks a bunch! I bet this will be a hot item (at least I hope it will be), BTW, is this part number a generic number!

 

When you eventualy get one for the SRT6 you can put me down for one.
I will keep an eye on this posting.

 

ill take 1 for the srt6. can you make it without the part#? i have the pulley saver kit so my belt # is different

 

Try this diagram.
What part number did you put on the NA label?

The Chrysler number for the NA is 05097758AA, and the Mercedes number is 011 997 97 92

The SRT6 number is 05143206AA and 112 997 00 92 resp.

That's what I get anyway. Could be wrong I guess.

The early listings ('04 and '05) for the NA say #05097785AA and were later corrected.

 

PP - $10 sent - thanks !

 

~ that was the only part number i could find online when doing a search... i will change the part number on the next run. however, it one doesn't want the generic part number on the bottom of the decal, i can trim this before shipping?

additionally, i will work on the srt diagram this coming week.

cheers ~ and thanks again!

 

Andrew,

Payment has been sent. I can trim off the part number when it arrives.

Thanks,

Tom

 

 

Andrew, these are great! Everytime I take my fan belt completely off I forget how it goes back..... and have to look it up.....

For part numbers, I think it would be much better to have the Gates numbers so you could just get them anywhere.... for the SRT6 the stock belt is 114.5" long, a Gates K081145 or Goodyear 4081145....

Just having the routing diagram is enough for me though... thanks for the support!

 

I think I am the first paying customer decal owner! BIG GRINS!

 

I'm glad everyone who purchased one of these decals likes them. It was my idea in the first place, and said I would have one. Unfortunately there is an additional $3 for Canadian buyers which I think is a bit too much.

Personally I think $10 is too much, but what the heck it's not my money. Enjoy.

 

Thanks Andrew....so did I

 

Andrew - paypal sent! And thanks so much again!

Bill

 

Sb-1 Serpentine For N/a
Sb-1 (2) Serpentine For Srt6

 

I'll take a sticker please for the SRT-6 belt routing using the NeedsWings pully saver kit. Squirrel Crusher

 

sir... your decal is free...

if it wasn't for you... who would have thought there would be a need.

send me your address and i will get an one on its way (the srt design will be here next week)...

cheers,
andrew

 

Very classy Andrew.

 

If I gripe about the cost, do I get a free one too ?
Just kiddin - 180 deserves a free one for his idea and contribution ........

 

I wouldn't gripe about the cost, just one time out in the middle of no-where and throwing a belt, I am sure folks would have paid 5 times that to get it on right (given many have a belt in their trunk hiding place). Cheers all! I know it will be a great sticker to have in my engine area!