CrossfireForum - The Chrysler Crossfire and SRT6 Resource

CrossfireForum - The Chrysler Crossfire and SRT6 Resource (https://www.crossfireforum.org/forum/)

- Troubleshooting & Technical Questions & Modifications (https://www.crossfireforum.org/forum/troubleshooting-technical-questions-modifications/)

- - replacing seat relay (https://www.crossfireforum.org/forum/troubleshooting-technical-questions-modifications/73332-replacing-seat-relay.html)

Well I'm have problems with my seats now..
I move them to an upright position to clean behind them and now they don't move. really pissed can barely fit in to drive what do in need to do take it to a Stealer?????

Quote:

Originally Posted by steps (Post 855399)

I take it you have tried to move them ;
1, With the driver door open and ignition off and on?
2, With driver door closed and ignition off and on?

Did you check the fuses #21 and #22 under the hood

Did you make sure that the plugs under the seats had not come apart even just a little?

If you push the door switch down with the engine off, can you here a relay under the dash click? If you have good ears you can hear it, if you are as deaf as me you will need to put your fingers on the seat relay and feel the click. It will click when you push it down and when you let it pop out again.

Click here for the .pdf on seat relay location.

thanks can't hear either,r it worked intermittently. I ordered a relay on ebay I now need to figure how to remove panel? where are all the screws? I only see two?

Thanks I copied the pdf

Checked 21 22 all good

Thanks