CrossfireForum - The Chrysler Crossfire and SRT6 Resource

CrossfireForum - The Chrysler Crossfire and SRT6 Resource (https://www.crossfireforum.org/forum/)
-   Troubleshooting & Technical Questions & Modifications (https://www.crossfireforum.org/forum/troubleshooting-technical-questions-modifications/)
-   -   Key Fab doesn't open or close locks (https://www.crossfireforum.org/forum/troubleshooting-technical-questions-modifications/80332-key-fab-doesnt-open-close-locks.html)

starduster Jun 23, 2019 06:00 PM

Key Fab doesn't open or close locks
 
Fuse # 9 blows. can't locate the short. Courtesy light, trunk light doesn't work. Key will open drivers door, but passengers door
will only open from inside handle. Switch on dash will open and close locks and trunk, but only inside the car when doors are closed.
Anything to do with the Body Control Module and if so where is it located? Thanks.

ala_xfire Jun 23, 2019 06:55 PM

Re: Key Fab doesn't open or close locks
 
Most likely you have gotten water into the locking pump module, located under the passenger side trunk flooring.
You gotta remove a heap of trim to get to it,
but you can go underneath the car and locate one of the rubber plug things and poke a hole in it to see if water is present.


All times are GMT -4. The time now is 10:54 AM.


© 2026 MH Sub I, LLC dba Internet Brands