Don't know if this happens to everyone, but i wouldn't think so. When i turn my window washer fluid on, the left side shoots way too high, usually if the blades aren't in the way it will shoot over the roof, and arc back down and land on my rear window. This gets very messy, and if it doesn't go that far. It usually hits the top of the window out of range of the wiper blades, and slowly drips back down while i'm driving, or it freezes up there. That's just the left nozzle, and there's 2 spots where it sprays from on each, so the left nozzle, left hole shoots high, but the left nozzle right hole shoots low. I think if i can just rotate it the right will go higher and the left will go lower. And overall the right nozzle is ok, but a little high also. Any tips on adjusting anything?