Thread: Need opinions
View Single Post
Old Oct 10, 2008 | 11:33 AM
  #10 (permalink)  
waldig's Avatar
waldig
Senior Member
Joined: Feb 2008
Posts: 4,508
Likes: 34
From: VA
Talking Re: Need opinions
JB is gookie BUT I used it to repair the oil pan when a pulley got Jiggey and ventilated it, it worked. NO oil stain, totally secure 6 months and a few races......

Chemistry lesson or cooking lesson: your choice.

2. Get a CLEAN wire brush, stiff and brush it (leak site) till it is CLEAN and roughened.

3. Get some new Acetone and wash it twice with a lint free towel.

4. Air dry it and then mix new JB, apply and sorta scrub it in before mounding it up for strength.

5. Test it, you only have 15 psi or so to deal with and if you do a Brian or Woody H/E the pressure should be dramatically less and there for no big thing.

1. If it is a LET H/E, call Jerry, he's a good individual and may take it back for the cost of shipping and weld it for you or just swap it out. I would send the money to buy a new one and have him swap it, returning the balance of the money as a core charge if your is clean and unmodified. THis is numbered as Step 1. , consider it. NO ASK< NO GET

Remember PUNKIN, THIS IS YOUR MONTH !!!!!!!!!!


WOODY
 
Reply
0