View Single Post
Old Feb 12, 2009 | 08:55 AM
  #5 (permalink)  
SRT6 Gang Member's Avatar
SRT6 Gang Member
THREE 6S
Joined: Aug 2007
Posts: 704
Likes: 0
From: From North TX..To SoCAL..Now Cnt Philly
Default Re: Datalogging IAT temps and C6 encounter

Originally Posted by SRTpowa
Ok I went out and played with the computer some more and I seem to have stuck my foot in my mouth with a previous statement in another thread.

Ambient temp was 55-60 F. Under 90mph WOT my IAT's were like I said in the low 100's , but I found out tonight I was around 150 anything over 90mph WOT. I ran it up to 140mph on one run and peaked 153 , it took only a couple seconds to drop back below 100 after I let off and soon dropped to a cruising temp of 75 on the hwy. So I guess I was a bit wrong on my statement before because previously I had only tested to 90mph on the street.

I neeed to get a serial to usb so I can datalog my new wideband. Just eyeballing it I am running 11.0 then it ramps up to 12.0-12.2 at 80 mph and stays there. So I think I have the fuel for the Code 3 pulley mid pulley(on order), but the IATs might not be so good like I feared. Guess I need to work on getting my N20 setup or just race 1/8 mile. All this really has me thinking our superchargers are pretty much maxed from the factory and not very efficient nor the intercooler.

So sorry if I mislead anyone before. Regardless the car still pulls like a beast, enough to edge out a brand new C6 from a roll. We stopped at a gas station and talked for a minute after wards. He was pretty surprised. Nice older guy with a nice ride.
Thanks for the test run. 153 is excellent for that speed , considering I reached those temps around 80-90 MPH. The 1/8th track is good for practicing launch techniques, collecting baselines with each mod you add and the oooooo’s/ awwww’s when you make a 7.8 pass. Which is my PB but I like to post ava runs. Running stacked pulley’s will defiantly increases those temps! Nice kill on the C6 .
 
Reply