Thread: Answer to 185 pulley
View Single Post
Old Apr 9, 2009 | 03:58 PM
  #11 (permalink)  
waldig's Avatar
waldig
Senior Member
Joined: Feb 2008
Posts: 4,508
Likes: 34
From: VA
Talking Re: Answer to 185 pulley
Got a few things out of the way, and this weekend Iam going to get on the rollers to get a baseline for my car. Next week I will be pulling the 178 off to go all the way to 185 and then after a week or more of goofing, Ill go back to the same dyno to get a power delta between them.

I will be getting my data logger on it also so that the data can be evaluated. I will also get a A/F reading in addition to my on board sensors. So after I get it all together Ol Woodeye will bring it to ya for review, Ta Da.

I have a few tricks waiting for the 185 setup and will see how much I can do with it. Iwill say that heat is not an issue and will defend that belief with data and charts. Brian Brave had a well put comment on the heat and I support it fully. When I get the chance Ill be at MIR again with the crowd to run it also for thoes that want each method of checking real power.

Good Bad or indifferent, Ill give you the real deal as I always try to do. So there is something to look forward to, assuming that your a shut in of have no other life..................smile

Woody
 
Reply
0