Thread: Boring out stock n/a throttle body
View Single Post
Old Apr 22, 2010 | 11:28 PM
  #3 (permalink)  
onehundred80's Avatar
onehundred80
Senior Member
Joined: Apr 2006
Posts: 25,432
Likes: 647
From: Ontario
Default Re: Boring out stock n/a throttle body
Originally Posted by 32krazy!
not hard at all. maxbore will bore the t/b and install a new butterfly for 125$ shipped
But if I did it for myself it would cost nothing, unless it flew of the lathe and stuck in the ceiling.
I'm not cheap, I just don't like spending money.
Rudy says the tough part is removing the shaft, I can see that being true, its OK Beaner I will not experiment on yours.
 
Reply
0