Thread: Installed a Code 3 intake and code 3 Pulley (GAINED NO POWER)
View Single Post
Old May 19, 2010 | 06:13 PM
  #50 (permalink)  
BrianBrave's Avatar
BrianBrave
<--- Huge Horsepower
Joined: Apr 2007
Posts: 3,217
Likes: 2
From: So Cal
Default Re: Installed a Code 3 intake and code 3 Pulley (GAINED NO POWER)
Originally Posted by Infinite
to the OP, honestly with all of these bolt ons you really need a tune to get the most out of the parts and to keep the motor safe
What's "un-safe" about a added filter and a slightly smaller S/C pulley??

When properly installed - it's promoted as the safest bolt-on mod on the market for the SRT6.... and the factory tune tends to be a little on the rich side..

I agree a tune is always in order.. Lean that puppy out a bit... Unless your planning on 1/4 mile glory... Then go take on your friend on again at the same roll...
 
Reply
0