Re: New fender strakes
I just pointed out that this part in ABS is not an easy part to make. The design would call for a quite complex mold and the part would have to be the correct thickness all over. These molds were being made at a rapid rate, too rapid for my liking.
There are some inconsistencies in the story and I just wanted some clarification. Is this a one piece molding or four?
To be a quality part it would have to have sharp edges and sharp corners, they would give the part definition. You can do that in plastic but fiber glass .... not so easily, fiber glass is good for curves and radii not sharp corners except where it is trimmed.
I am all for someone making parts for these cars but we have seen lots of Photo Shopped ideas but no actual parts.
The master part should fit on the car otherwise it's not a master part.
Show me and I will believe.