Thread: WTB: Shims for the 1st gen (?) C3 pulley
View Single Post
Old Dec 20, 2010 | 02:09 PM
  #7 (permalink)  
onehundred80's Avatar
onehundred80
Senior Member
Joined: Apr 2006
Posts: 25,432
Likes: 647
From: Ontario
Default Re: WTB: Shims for the 1st gen (?) C3 pulley
Originally Posted by oledoc2u
Too bad, there is sure a market for them...I haven't found any machine shops around here to tackle it...tooling in all....
Shims are actually made for a wide variety of uses and a lot of them can be purchased off the shelf.
Generally the ID or OD are important but the other diameter is often less so.
Let me know the ID and the OD and which one is important and I will look.
Custom shims require the tooling to make them and no one is going to make a set up for a few bucks.