Originally Posted by
jsaredwings
i just saw it too and was thinking man i know i dont go on the forum very often but thought i would have seen this! i have to agree way too expense, hell i was on the fence shelling out 500 for one but did.
as for the rpm problem i do not know however i do know there were concerns about the longterm durability of something smaller. i believe several people have had there pulleys milled down below 65mm to low 60's
I thought it would be not enough to mill down after 64mm as the material walls would be too fragile. Just what I heard on this forum and that was one of the causes EC did not lower the mm. I guess 64.7mm is good enough for me. Also 1000$ for something you really do not have any warranty nor history on ? Not my cup of tea. But hey, go for it
