Originally Posted by
bigblock427
Hi Josh,
i think we talk past each other. Camshaft and Crankshaft Position Sensor work together. You can't generate the position of the 1 cylinder from the Crankshaft Position Sensor, because you have 4 strokes and 8 cylinders.
I'm not talking about the signal that is sent by the ECU to the Camshaft Position Sensor. I talk about the signal that the ECU gets back from the Camshaft Position Sensor. This has to be a clean square wave signal on the oscilloscope.
Regards
Markus
Markus,
Understand you
.
I did find the Crank sensor wires were against the O2 sensor
. So I re-wired them. I also found the 40 AMP fuse on the relay control module popped!
. So I replaced it. All said and done, it drove worse with the cam sensor plugged in
. I briefly checked the ECU to no avail.