Re: Rear winged emblem
Just replaced my front and rear emblems. Drill small holes 1/8" diameter vertically 5 or 6 in the center from top to bottom. Not to deep just barely through the clear top dome maybe 1/16" to 1/8" take your time be careful not to deep. Then I took some very small sharp diaginal wire cutters and cut between the holes until you can grab it and twist easy and pull the 2 halves out one at a time. Just dont drill to deep it was a very easy job to do. Hub caps too, replaced all 6 with new crossfire emblems. Looks great.