Hey everyone need your help.

On a long trip after pulling over to a rest stop my crossfire would try and start two times then third time absolutely nothing.All lights on dash and exterior lights all functional but, it won't even crank. I had re-soldered my RCM a few months ago even though the contacts looked good and I have had no problems afterwards or previously.

My crossfire has been at the dealer for two weeks and the diagnosis was a new SKREEM module. Long story short they tried to program this SKREEM module with a new fob key but, no success only to have Chrysler Engineering tell them the modules are already pre-programmed. (They said it was a full page of instructions which take 45 minutes each time and they tried over 10 times). Chrysler Engineering has provided the tech with 8 separate scenarios for this problem which who knows how long will take.

Can anyone guide me to anything I can print out and show the tech for possible solutions. They are burning hours looking for a solutuion.

Thanks a ton in advance.