I already broke my new toy . last week installed sl55 intakes , sell forgot to ship tube that go from front of car to sir cleaners . installed the system minus front tubes . tested it and it was fast! after the 4th or 5th run it went into limp mode then thru a cel . pulled over did a tps recal and it didn't help .

next day installed front tubes, disconnected battery for 2 hours . hooked it back up did another throttle recalibration . took it for a run , had about 80% of normal power , then went into limp and thru a cel again .

today drove it , cel on. had good power but didn't get on it all the way.

does the computer take a while to relearn ?

should I not full throttle for a few days ?

any ideas ?

ordered a obd2 thingy and am downloading torque pro. wont have for a few days