Originally Posted by
GraphiteGhost
Didn't finish reading/comprehending the entire article due to the annoying pop-ups, but a subtle hint for reassembly, is to keep the new bearings in the freezer until they are to be installed in the hub. This 'shrinks' the bearings allowing them to be a little easier to install. Of course, make sure they are not crooked (as the article mentions). Good luck, and come back to tell us how it worked out!
.
George, I think you are talking about the bearing RACES, not the bearings.
No point in putting the rolling part in the freezer unless you plan on roller bearing soup for supper in the future.