Xfire not sure how to do that especially since the BCM is on big connector. What I did do was shoot each pin to ground to see if anything is reading continuity to ground. I have found 5 pins that have continuity with ground that I don't believe should, at lest by my knowledge of the system and diagram.

1. Central locking/pump and security system module
2. Instrument cluster wake up
3. Spoiler limit switch up (disregard)
4. Turn signal monitored ground (disregard)
5. Washer pump motor control (disregard)

The spoiler is in the up position and is actuating the little switch on the left side which I believe is the up and even with it disconnected it still blew fuse 7. So I think I'm good to eliminate that one. (Is there a way to force the spoiler back down, by hand not by switch?)

Disregard turn signal ground, damn turn signal switch was on.


Disregard the Washer Pump Motor because its always grounded

Any thoughts?