Thread: What did you do to your Crossfire today?
View Single Post
Old Jan 8, 2018 | 09:08 AM
  #5507 (permalink)  
onehundred80's Avatar
onehundred80
Senior Member
Joined: Apr 2006
Posts: 25,432
Likes: 648
From: Ontario
Default Re: What did you do to your Crossfire today?
Originally Posted by STRANDD
Spent parts of the last three days replacing the heater blower motor on my S-10 pickemup and replacing the crankshaft and cam position sensors on both the SRT and the N/A roadster. May not be a huge accomplishment for most of you wrenches but it is for me. Info gleaned from this forum was invaluable (well....not for the S-10)! Thanks all!!
I do not look upon those sensors as wear items and when replacing them you might put in a part that fails earlier than the one you took out would have. The connectors getting dirty may be a possible cause of failure, so a cleaning might be in order.
Replacing them with parts that are not Bosch parts often leads to early failure and not recommended as the terminals are thinner it seems and do not make good contact with the harness socket.
I think I am repeating the general opinion on these parts.
 
Reply
0