View Single Post
  #19 (permalink)  
Old 07-08-2018, 10:42 PM
turbomar's Avatar
turbomar
turbomar is offline
Senior Member
Join Date: Jul 2011
Location: Barrhaven, Ontario
Age: 60
Posts: 914
Likes: 0
Received 3 Likes on 3 Posts
Default Re: Cylinder Misfire Help

Originally Posted by jamesmonter2
I triple checked all the wires. All the wires are brand new. I switched out the new coil with an old coil, same problem. I made sure the boot was seated on the plugs properly as you need to push hard. I disconnected A & B on the pack and re connected to make sure the wire went on the prong. All wires are connected properly. The cars still runs rough. Has no power when you hit the gas, and sounds like it is sucking in air alot when i hit the gas pedal. It takes a few seconds for the car to rev up after i hit the gas, almost like the gas hasnt hit the cylinder yet or too much air? I check the MAF sensor and the elbow under to make sure thats tight, I cant hear any air or vacuum leaks. Any other suggestions?
Switch #2 coil pack connector with #6