My thinking is to take the BOM original flasher which I am assuming is similar to an older style thermal flasher type and replace it with a solid state version. The installed can bus led provides the onboard light status surveillance control with light status state input. Hyperflashing is a common condition when converting and there are substitute replacement flashers available. Installing a resistor could involve a lot of location placement searching which I am not interested in doing if I don't have to.
At this time knowing the flasher p/n or its physical location would be helpful in researching a potential replacement. I have not been able to find any documentation showing the flasher p/n and/or its location.
Thanks, Jack