Hello again, as I was testing the amperage, I would wait for about a minute each time when the ready steady out and go with that reading. So I decided to clamp the multimeter probes to the battery post and clamp and start pulling fuses again. I got distracted for a few minutes and when I looked over, the reading had dropped to 0.01 and stayed there. So I tried it many times again and It took approx 1.75 minutes for the draw to drop down from 0.160 to 0.01, and then it stays there. Would this be normal and the siren was my only problem. Everything now is steady at 0.01 Ma. Thanks for your thoughts on this matter.