The NA sill will be in this coming week (dec 28th-31st). I will honor the pre-order special until the 31st of Dec. of $60 with free S&H to the continental US ($10 discount to other areas). I will ship upon receipt of product and payment.

Send your email address and I will invoice via Paypal.

Thanks to all those who have already prepaid. Your orders will ship this coming week.

 

Thanks for the update, can't wait. After the snow is gone, I can give Bridgette a wash and install her new door sills.

 

Thanks Karl,
I'll be watching for them.
Which carrier will be delivering them to my house ??

 

The NA Sills have arrived! Shipping on the 30th via USPS to all pre-orders.

I will still offer free S&H to the continental US on order received by the 31st. ($60 per set - PM me with your email address so I can invoice via paypal)

I laid the new strip over my SRT6 Sill to snap the photo. I think they came out VERY nice.

A special thanks to those who pre-ordered. Need lots more to break even!



NAsillsoncar.jpg?t=1262145832

 

They look excellent !!!
Looking forward for them to arrive at my door.

Gary

 

That looks Great! Can't wait to get them installed. Thanks for all your hard work, time and money.

 

Glad I finally got enough people on board for these, I have been waiting like 6 months LOL

Like a kid on christmas morning. They look exceptional Karl, nice work.

 

Karl,

PM sent

 

Payment sent via paypal.
Thanks, they look great!!

 

Mine arrived today! They look GREAT!! Thanks again Karl. Any suggestions on the install? Just clean the sills, peel and stick, or should I warm up the sills first? (Still below freezing here).
Thanks again

 

Unfortunately I have the same question

 

I should have included instructions, sorry...

First clean the suface of the existing sills and wipe with alcohol. That will make a nice clean surface. Depending on the temperature (below 45 is probably a good point) you may want to "warm" the new sills with a hair dryer a bit (careful if you are using a heat gun, they get very hot and could melt the polyethelyne). Then just peel and stick. It is a good idea to match up the end closest to the back edge of the sill, then gently lay down the top edge to align with the sill then press down. They will come up easily if you don't get it lined up immediately. You can then reposition till you get it right.

Thanks again for your orders. Glad you like them.

Karl

 

Mine came today

 

Karl good job with the seals got mine laying in the living room on the coffee table flatening out. Waiting til warm weather to install them. You should make custom messages to go under the spoiler I imagine these would sell fast as well.

 

+1

Karl, as with the other products I have receieved from you, the sills look great and I can not wait for it to warm up so I can install and enjoy.

The idea about the under spoiler decals is a great one, although since you are an SRT guy, the chances of you taking on a job exclusively for the NA is probably not that great....

 

Put em on today....here are the pics....

 

Hey Gary, that looks as good as mine do. I finally had a decent day and was able to get my Bridgette clean enough to put my new sills on.





Karl did a really fine job on these sills, adds a nice touch when you open the doors.

 

Thanks everyone. I appreciate the kuddos

 

Somehow they look nicer with CICCI mats......

 

I know, I know. I'm working on that, hopefully before CAA 2010.