Here's a little quote I borrowed from LET
"This C32 pulley will bring the boost level of the C32 up to 18 PSI for the 178mm and 20 PSI for the 181mm. Includes water pump pulley.".

With that in mind I'm gonna guess that the 185mm pulley should put the car around 22-23psi.

 

with going with the 185 although noone has done it yet do you guys think the car will still be reliable as a daily driver?

 

sorry asp doesnt want to go bigger then there current pulley set, sorry. are bigger pulleys currently available for sale/shipping or just in the works? does anyone here currently have a srt6 running with an 18x mm pulley?

 

I'm guessing people will start to jump in once it gets a little closer to spring.
March would be ideal for me (intake and pulley).

 

LET says they have 181mm pulley sets with a 30 day lead time and they just released the 185mm........I believe.

 

Are you still doing the combo deal for the intake and pulley? I would be interested. I know I am way behind. I just joinded the forum last week. Thanks.

MikeR

 

yes we can do the same combo we did earlier, if enough guys are ready ill start a new thread, if you dont want to wait for the next gb to go thru pm me and w can work out a deal without the wait time

 

I belive a few people have just received the 185mm pulley I know of one crossfire owner for certain he has not left feedback yet, but there are a few c32 owners running the 185mm pulley with sucess.. according to them with this pulley the ECU MUST be tuned and additional cooling equipment is a MUST as well..

185mm pulley should not make the car unreliable as it is still quiet a range from the superchargers maximum and as stated previously with cooling mods it should not put any extra stress on the parts

BTW how are your products coming along?


and moparbust the 185mm pulley has been released a while ago

 

I should be ready later in the spring...

 

does anyone have their asp install page handy, i have someone asking me for it since they lost theirs and ours is burried under 2 months of receipts, if not i can get it on monday but was hoping to get this taken care fo before then, thanks, rob

 

Needswings,

With this being my daily driver, I can't afford to effect the 200k miles I want to put on it. With a 178mm pully and your CA intake, do you think I will lose in the long run? Also how will this effect the gas mileage?

I know I saw prices somewhere but could you give me an idea with those two as a package?

Thanks

 

pm sent with instructions

 

Does this pulley require upgraded fuel injectors or retune of the a/f ratio?

 

Neither is required. Some people get a tune as well, but some don't.
Chi-town SRT6 did a great write up 'how to build a fast Crossfire' (I think). It covers a lot of this information.

 

Okay, I will check that out. Thanks

 

thank you!

 

no, it does not require either

 

i dont have a crystal ball but we have both parts on our car without worries, i dont forsee any issues with either parts, especially since were only looking at a ~ 20% increase in power to a fully forged internal engine.

the CAI in theory should help gas milage but i dont have a mythbusters gas consumption testing device to prove it. pulleys shuld not effect milage assuming you are driving normally without going W.O.T. everywhere.

the total for those that were in the group buy was 1273 shipped for the cai+pulleys

 

Is any one using software??

 

Hey John good to see you made It to the site. I am yet to receieve an email from you hopefully will be recieving it soon.