installed eurocharged 181 pulley, car won't start
 

I have triple checked everything. Since eurocharged does not provide instructions a fellow memember sent me the let pulley instructions which helped a lot. But im sure there are some differences. Timing seems to be off. It cranks up hesitates, and dies down. what should i be looking for???? Thanks

Re: installed eurocharged 181 pulley, car wont start
 

That is odd... just swapping the crank pulley shouldn't cause your problem.... unless maybe the pulley is slipping on the crank???:confused:

1. did you get the new pulley seated all the way?
2. did you use a new bolt?
3. did you get the bolt tightened to spec?

That is all I can think of that could go wrong with the swap....(other than damaging the front seal)...:mad:

Keep us posted....

Re: installed eurocharged 181 pulley, car wont start
 

Well now that u mention it. I used some pb blaster to get the crank bolt out so when i put in th new crank pulley some of it might have gotten on it. I just talked to jerry, he said i should check the flywheel since thats how i got the bolt off. Whats should i check for on the flywheel?

Re: installed eurocharged 181 pulley, car wont start
 

Re: installed eurocharged 181 pulley, car wont start
 

Checked the fly wheel. It rotates when i try to crank it up. Checked all vacuums. It does not seem like the pulley is slipping. Any way to check if i installed the idler pulley wrong, or the crank? I didnt put it in the oven because it was a perfect fit. Should i have done that? Anything else??

Re: installed eurocharged 181 pulley, car wont start
 

Did you check your belt routing?

see srt6 diagram here :https://www.crossfireforum.org/forum...y-diagram.html

Re: installed eurocharged 181 pulley, car wont start
 

yes that was the first thing i did. it was included in the instructions

Re: installed eurocharged 181 pulley, car wont start
 

Re: installed eurocharged 181 pulley, car wont start
 

sounds electrical,,you could have knocked off something electrical ,,unplug and replug all plugs near where you were working. jim

Re: installed eurocharged 181 pulley, car wont start
 

This is just a shot in the dark, but could the battery be weak from leaving a door open or light on while you worked on it. Enough to crank it but not enough to sustain...as I've read really strange things can happen when the battery is weak.
I know its a long shot but worth considering????

Re: installed eurocharged 181 pulley, car wont start
 

took ur advice and it did not help. i have reset the battery a few times also. its throwing a code. can anyone tell me how to get the codes from the dash. thanks

Re: installed eurocharged 181 pulley, car won't start
 

Get a cheap scanner from Wart Mart, and go from there. Stop guessing and wasting time. Once you get the code we will know what to do.

Re: installed eurocharged 181 pulley, car wont start
 

Well?? I'm curious what the problem turned out to be?

Re: installed eurocharged 181 pulley, car wont start
 

You must have missed the later posts. Here's where it gets messy ....................https://www.crossfireforum.org/forum...on-sensor.html

and then it get downright fugly
......https://www.crossfireforum.org/forum...-flywheel.html

Re: installed eurocharged 181 pulley, car wont start
 

I did miss seeing this, and like you said...... Holycrap!! Damm it man, sorry to here about this.:(