Srt6 tbi?
Re: Srt6 tbi?
If the bore that it feeds is 74 mm then you are wasting your time, also you should add a 74 mm MAF or you are wasting your time. Air should flow through a constant diameter bore or you get turbulence which is counter productive.
Join Date: Jul 2009
Location: Central South Carolina
Age: 69
Posts: 5,842
Received 375 Likes
on
325 Posts
Re: Srt6 tbi?
Don't forget to use your original sensor in the housing (the MAF housing). Also, trim out the baffles and screen in the curved intake below the MAF and above the TB. Good luck!
.
Re: Srt6 tbi?
I think that is not quite true, mine and many others ran as if there was no mods done, a few had to do a few runs before irate settled in and one or two had to do a few hundred miles before it settled down. Odd but that was what l recall.
Re: Srt6 tbi?
I just installed an unmodified 74 mm and had no issues at all.
Re: Srt6 tbi?
I did not remove baffles or screens, why bother as any increase in power would be unnoticeable. HP at the rear wheels would about 190 to 195 at best.
A year later I got the SRT. I