Power Capacity Stock Diff?
Anyone got an educated guess on the diffs power limit? Also is it named as a Chrysler HAG-190. Looking at what parts will be needed for a 350hp project car which will not see a drag track and will be lighter than stock.
I have just under 600 HP on a stock crossfire rear ,, but it is 3.45 gears and about 6 months i added a wavetrac so your good. & with drag radials. jim
\
car V8 #1,, 638 1/4 mile runs 1 failure u-joint on drive shaft.at run 532 ,,,sold
car V8 #2 212 1/4 mile runs no failure,,,, sold car v8 #3 so far 6 1/4 mile runs, runs 10 52 @137 3.45 rear borrowed dr for 3 runs all 3 in the mid 10's. i have a 3.45 I can sell u,, open stock rear. the yoke depends on what drive shaft u use srt6 larger yoke than limited shaft yokes that is, use a Mercedes engine , V6 or V8 MOST will fit ,mounts ,drive shaft it is a bolt in .
jim
car V8 #1,, 638 1/4 mile runs 1 failure u-joint on drive shaft.at run 532 ,,,sold
car V8 #2 212 1/4 mile runs no failure,,,, sold car v8 #3 so far 6 1/4 mile runs, runs 10 52 @137 3.45 rear borrowed dr for 3 runs all 3 in the mid 10's. i have a 3.45 I can sell u,, open stock rear. the yoke depends on what drive shaft u use srt6 larger yoke than limited shaft yokes that is, use a Mercedes engine , V6 or V8 MOST will fit ,mounts ,drive shaft it is a bolt in .
jim
Last edited by amx1397; May 8, 2026 at 08:15 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)



