Little "phat" lip
5 Attachment(s)
Just finished attaching my Cupra R front lip last night. Two and a half hours on a cold garage floor—what do you guys think?
It's an universal spoiler made in Spain. I've seen them used for Audi TT's, A4's and Golf's, but never a Crossfire. It actually fit pretty nice. The width is perfect, I had to trim the middle posts down and shave off some depth, our front bumpers are pretty short. I ordered if from OEMPlus, (it took about 5 weeks). Attachment 47198 Attachment 47199 Attachment 47200 Attachment 47201 Attachment 47202 |
Re: Little "phat" lip
Looks good....
|
Re: Little "phat" lip
I'd go ahead and give that one the seal of approval. Looks pretty darn sharp.
Nice work. :D |
Re: Little "phat" lip
Actually that's pretty nice. I bet painted the color of the car looks even better.....
|
Re: Little "phat" lip
looks good, great job. jim
|
Re: Little "phat" lip
What did you do to mount it? I'm sure you had to drill into the bumper.
|
Re: Little "phat" lip
Thanks guys. FP - I'm actually thinking of painting it body color, when I get my front wings painted the same.
|
Re: Little "phat" lip
I like! ...Squirrel
Crusher |
Re: Little "phat" lip
I mounted it with fourteen #10 3/4 zinc coated bolts. All of the holes are pretty far down, don't think it should be any problem if removed. I'm thinking of using some 3M tape also if I get it painted. Might also use some metal sandwich trim clips for some extra support in a couple spots. All in all its pretty damn solid, but I'm still going to be cautious with curbs and large speed bumps.
|
Re: Little "phat" lip
Looks really nice , I like it.... :)
|
Re: Little "phat" lip
Fantastic job! I might even implement that as a substitute until the SRT bumpers start getting produced again...
Body color would look great, CF would look even better. Then again, I'm a CF junky. :cool: |
Re: Little "phat" lip
I think it looks nice also. Great job!
|
Re: Little "phat" lip
Very SRT-6ish. Experimentation is good. Congrats.:)
|
Re: Little "phat" lip
Looks really good ... how difficult would the mod to the part be for a "non-techie"?
|
Re: Little "phat" lip
Very nice............I like and I'd leave it black too!
|
Re: Little "phat" lip
Hey Kim - Getting it lined-up and drilling the first hole is critical. Everything after that is really not that hard. I bet a body shop or even local mechanic could do this in their sleep for minimal cost.
Tp: I pre-drilled all the holes on the spoiler first, one hole for each tab, and make sure its centered. Just take your time. Good luck. |
Re: Little "phat" lip
Really looks quite nice. If I already didn't have a SRT nose on mine I think that I would go with that. I would leave it black on my Blaze Red though.
|
Re: Little "phat" lip
very impressive srt6ish it is
|
Re: Little "phat" lip
Looks great - do you have any pics froma little distance too?
|
Re: Little "phat" lip
It looks very good!!
|
All times are GMT -4. The time now is 01:23 PM. |
© 2024 MH Sub I, LLC dba Internet Brands