sprayer onto windshield plugged
One of the sprayers the shoot the liquid onto the windshield is not spraying anything, the other side sprays a bit. Something I can do to fix or does it need professional attention? Thanks
|
Re: sprayer onto windshield plugged
there are a couple of threads here that might be helpful in solving your problem if you have already tried to clear the nozzles with a thin piece of wire or something similar. that is the place to start. after that, just search the forum for "nozzle" or "washer" or something related to the item.
|
Re: sprayer onto windshield plugged
Originally Posted by J.J.
(Post 897197)
One of the sprayers the shoot the liquid onto the windshield is not spraying anything, the other side sprays a bit. Something I can do to fix or does it need professional attention? Thanks
Pump some fluid through the hoses before putting the nozzle back in position, this will clear the hoses of any more potential blockage. |
Re: sprayer onto windshield plugged
I just forced a straight pin into the opening that was completely clogged and was able to get it spraying again like new.
|
Re: sprayer onto windshield plugged
Originally Posted by onehundred80
(Post 897200)
The nozzle housing snaps open and a ball shaped nozzle comes out, you can clean it with a small wire.
Pump some fluid through the hoses before putting the nozzle back in position, this will clear the hoses of any more potential blockage. |
Re: sprayer onto windshield plugged
Originally Posted by fyrepower
(Post 970399)
I am getting ready to replace my washer reservoir and pump because of slime build up. So if I remove the nozzle housing and the nozzle I would then be able to use compressed air and blow it through the hoses?
|
Re: sprayer onto windshield plugged
Originally Posted by MrFister
(Post 956734)
I just forced a straight pin into the opening that was completely clogged and was able to get it spraying again like new.
|
Re: sprayer onto windshield plugged
Originally Posted by onehundred80
(Post 897200)
The nozzle housing snaps open and a ball shaped nozzle comes out, you can clean it with a small wire.
Pump some fluid through the hoses before putting the nozzle back in position, this will clear the hoses of any more potential blockage. Thanks |
Re: sprayer onto windshield plugged
Originally Posted by fyrepower
(Post 970468)
Does just the end of the nozzle housing open. I have been trying and the whole housing came part of the way out but I don't want to break anything. Should I try a small screwdeiver or pocket knife to try and loosen it.
Thanks https://cimg8.ibsrv.net/gimg/www.cro...881f29f34e.jpg |
Re: sprayer onto windshield plugged
Originally Posted by onehundred80
(Post 970474)
|
Re: sprayer onto windshield plugged
Originally Posted by fyrepower
(Post 970572)
does the top of the housing come off? I was able to get the nozzle housing out of the cowl but I did not want to break any thing.
|
Re: sprayer onto windshield plugged
Originally Posted by onehundred80
(Post 970574)
The top just hinges up at the opposite end to where you press the clip in.
|
All times are GMT -4. The time now is 12:26 AM. |
© 2024 MH Sub I, LLC dba Internet Brands