Little "phat" lip
Little "phat" lip
Just finished attaching my Cupra R front lip last night. Two and a half hours on a cold garage floor—what do you guys think?
It's an universal spoiler made in Spain. I've seen them used for Audi TT's, A4's and Golf's, but never a Crossfire.
It actually fit pretty nice. The width is perfect, I had to trim the middle posts down and shave off some depth, our front bumpers are pretty short.
I ordered if from OEMPlus, (it took about 5 weeks).
CupraRspoiler3-4view.jpg
CupraRspoilesideview.jpg
CupraRspoilefrontview.jpg
CupraRspoilenotmounted.jpg
CupraRspoiletrimhere.jpg
It's an universal spoiler made in Spain. I've seen them used for Audi TT's, A4's and Golf's, but never a Crossfire.
It actually fit pretty nice. The width is perfect, I had to trim the middle posts down and shave off some depth, our front bumpers are pretty short.
I ordered if from OEMPlus, (it took about 5 weeks).
CupraRspoiler3-4view.jpg
CupraRspoilesideview.jpg
CupraRspoilefrontview.jpg
CupraRspoilenotmounted.jpg
CupraRspoiletrimhere.jpg
Last edited by H82BL8; 01-13-2010 at 10:04 PM.
Re: Little "phat" lip
I mounted it with fourteen #10 3/4 zinc coated bolts. All of the holes are pretty far down, don't think it should be any problem if removed. I'm thinking of using some 3M tape also if I get it painted. Might also use some metal sandwich trim clips for some extra support in a couple spots. All in all its pretty damn solid, but I'm still going to be cautious with curbs and large speed bumps.
Join Date: Dec 2006
Location: Murfreesboro, TN
Age: 39
Posts: 6,348
Likes: 0
Received 10 Likes
on
10 Posts
Forum Regular
Join Date: Dec 2007
Location: Seymour, IN
Age: 61
Posts: 306
Likes: 0
Received 0 Likes
on
0 Posts
Re: Little "phat" lip
Hey Kim - Getting it lined-up and drilling the first hole is critical. Everything after that is really not that hard. I bet a body shop or even local mechanic could do this in their sleep for minimal cost.
Tp: I pre-drilled all the holes on the spoiler first, one hole for each tab, and make sure its centered. Just take your time. Good luck.
Tp: I pre-drilled all the holes on the spoiler first, one hole for each tab, and make sure its centered. Just take your time. Good luck.
Last edited by H82BL8; 01-11-2010 at 08:23 PM.