Thread: Molded Carbon Fiber dash and body pieces
View Single Post
Old Apr 24, 2007 | 05:39 AM
  #1 (permalink)  
SRT SIX's Avatar
SRT SIX
Senior Member
Joined: May 2006
Posts: 3,027
Likes: 5
From: Folsom, CA
Default Molded Carbon Fiber dash and body pieces
I had a previous post about the best looking carbon fiber dash kits. Those came from Germany and I could not get a reply from them. Tino at CTD knew about them and told me they were ultra expensive and required sending your components to Germany to be finished.

I just found a shop in SoCal that does this kind of work. I visited them and got to see how it looks. OUTSTANDING! This is not a flat self sticking piece that affixes to your dash. That kind will only cover the flat surfaces with the silver around the beveled edges showing...it looks stuck on. This process molds completely around each part and is polished. The parts look like the pictures of the ones from Germany. With those you have to send the pieces you want to Germany. They apply the carbon fiber finish over them then ship them back. It completely conforms to the surface and around the edges.

Here are pix of the German ones. These are shown in red but the only colors are silver and black. The black carbon fiber is HOT!

(They don't do the steering wheel)

They can also do engine covers and exterior pieces.

Exterior
windshield molding (3 pieces) $175
door handles (for both doors) $90
fender strakes (all six) $135
grill $195

Engine area (Yes it is heat resistant - they even do valve covers)
Custom SRT6 belt cover (not including the crosshatch part) $195
SRT6 Air filter covers (2 pieces) $120
I'd have to ask the price for the regular Crossfire cover it can be done as well.

Interior
door handle/speaker surround (2 pieces) $60
door grab bar (2 pieces) $90

Center console stack (includes the following silver pieces-not including switches or dials)
center a/c vent
a/c control
ashtray
switches
airbag light
lighter
shifter ring
shifter base
center console
drink holder door
storage console lid - total $275

Instrument visor edge (the entire flat area even over the top) $60

When you consider the cost of just the chrome rings for the instruments, these prices are very reasonable for quality custom work.

The only downside is having to remove the pieces and have them sent in. Small price for custom work. BTW they can do almost any parts for most any vehicle (they were even doing some guitars while I was there).

If interested, post or PM me.
 
Reply
0