Originally Posted by Mike-in-Orange
The G110 has a bit more torque than the 7424 and a different handle - those are the primary differences. The extra torque will help keep a pad spinning as it loads with product, and the bale style handle helps you put pressure directly over the head of the unit rather than a stick off to the side that can cause you to easily roll onto the edge of a pad. A fine distinction, yes, but there it is.
meguiarsdirect.com is our e-commerce site but it's actually run by a third party for us. As such we sell everything at full MSRP - it wouldn't be too cool of us to offer lower prices than our retailers and distributors, you know? Take a look at
www.autodetailingsolutions.net - great prices, very fast shipping, and they stock
everything we make.
Just finished using my new Porter Cable Polisher and I have to say that it needs the bail type handle as seen on the Meguiars. Also I think that the PC needs a smaller diameter at the rear to hold on to, just like some of the rotaries.
I finished up the last half of the car with the swirl remover, polished and then waxed and my wrist was sore, numb in fact. These two mods would make it less tiring.
Whats the bet that the new PC polisher model is made in China instead of Mexico? Will it be cheaper or more money for a "new improved model'. I am betting more, so my recommendation is to buy the Meguiars model.
I used Meguiars products throughout and as its the first time I have seen the car polished, I was impressed. I hate to take it out now, but black looks good for five minutes at least. I can already see the dust on it five hours later.