I live in Illinois and we need a front license plate!!!! BOO!!!! I don't want to drill holes for an OEM holder, and since I have an SRT, I have an Altec flip-up holder I want to install! I find that the bottom part of the front bumper(where the altec holder attaches, is very flexible. In looking at the possible points of installing it, and I find that the rear attachments would cause the bumper to flex with wind resistance and contact between the holder and the face of the bumper, would cause Bumper damage. How did you ("you"... that have the Altec holder), solidfy this mounting? This may only be a problem with the SRT front bumper! I know there are urethane cushions that can minimize this, and I will use them, but I'm looking for ideas on how this unit can be stabilized.