Originally Posted by
onehundred80
There is a vacuum line from the engine to the throttle body elbow (driver side) is that snug?
Also there is a gasket in the top of the MAF elbow and that could get torn if the MAF housing is pulled of it to roughly, an air leak below the MAF would not be good. There are instructions here in one post that says to literally yank it off.
Sorry if I repeat steps you have done but I have run out of ideas.
Yup, I checked both of those really well when I reconnected everything
The hose on the driver side is snug and I know that rubber ring is good.
I really appreciate all the ideas, guys.
Thanks