Re: Front to rear hatch divider(behind the seat)
Originally Posted by
Padgett
180's pics are the best I've seen but here is what the seat looks like installed (I didn't remove the seats just moved forward and out of the way, also just modified behind the driver's seat, that is a nice and complete job. I would remove the rear wall down to that level if going that far. You do not have a tonneau that needs to register on it.
Note: the seat rails were also raised 1/2" (if the wheel don't tilt...)
The pic I show of the bulkhead from the front is wrong, I think that is a modified one. I looked at it again and it is not the way the OEM chassis is built. There is about a 8" above that. There is another pic that shows it better but not so close.
Last edited by onehundred80; Jan 22, 2014 at 06:26 PM.