Well, a new never ending story; Dung out my CLPM as stated earlier. Put everything back together, I'm hoping it is right, couldn't remember exactly. Tried to us logic and the form around the unit. So then hooked battery back, went to NAPA, got contact cleaner, dialectic grease and a new tie down for the wires. Got home decide to wait till morning, to tackle the clean and grease. Lock car using fob. a few minutes later(less than 5), quickest ever, the lights blinking. One press of unlock button, the lights stopped blinking, A couple of minutes later, car locks itself and a few more minutes, lights start blinking again. So this time press unlock button twice. lights stop, doors and trunk unlock, but wait a few minutes goes by, car locks itself again and few more minutes car starts blinking again. So I said I'll try what I did last night, I open the drivers door, lock everything and then unlock only the drivers door, all this with the fob. And been a couple of hours now and no blinking lights. So I guess when I had the unit out checking for moisture, I might have loosen something? If any one has any suggestions on my next course of action, I would greatly appreciate it. I found (I think) the two door sensors, but for the life of me, I couldn't find one for the trunk or the hood. So unless some one here in Florida is willing to help me out, next stop is a dealership. I'm willing to travel any where in the state or you welcome to come here. And I'm willing to pay you for your time and help.