Originally Posted by GraphiteGhost

I bought ( https://www.hardwarefactorystore.com...-tool-kit-new/ ), they are on sale and are a vac style. Onle issue you will have, is making sure you do not run out of fluid (watch the master cylinder). I am a good 'instruction' follower so I'll be sure to let everyone know how it worked out. George, I don't quite understand how these 'bleeders' work AND know I have to remove my existing, so I am not comfortable with them. I'm not opening up the system if I can help it. I know many like them, its just a personal choice.




I got this one ( https://www.hardwarefactorystore.com...-tool-kit-new/ ), on sale and it also has free shipping , should be here soon! Jack stands go on my lower rear control arm locations where they will not get bent in any way (its been a while but I think it is where the bolts are). Front, same thing where they fit without damaging/bending anything. Good luck!


The instructions of the bleeder are attached below.

.