Originally Posted by
ala_xfire
Simply connect a 2 wire lead across the clutch connector to a LED, observing polarity with maybe a dropping resistor in series.
Run the wire up to the cowl by the driver's windshield and tape the LED to the lower part out of the line of sight.
Bada Bing, Bada Boom.
Reviving an old thread here. I'm finally getting around to installing my light. I have a single 3mm 12 volt LED light rated at 12 milliamps, what size resistor would be best to place in series? I assume that the resistor is so the led light will last longer, not be too overly bright?