Thread: DRB III Emulator?
View Single Post
Old Aug 30, 2019 | 03:08 PM
  #9 (permalink)  
dedwards0323's Avatar
dedwards0323
Senior Member
Joined: Nov 2008
Posts: 8,469
Likes: 841
From: Upstate SC
Default Re: DRB III Emulator?
Originally Posted by John&Terry
You will need this:
1) Good computer knowledge
2) A laptop with a clean Windows XP or Windows 7 installation on it. Nothing else. Networking and Updating turned off.
3) A Micropod 2 Clone V17.04.27 wiTech MicroPod 2 for Chrysler Diagnosis & Programming Tool Multi-language
4) Follow these instructions How to install DRBIII Emulator for Micropod 2 on Windows 7 Pro 32-bit | OBDII365.com Official Blog
5) A TPMS tool to "chirp" the sensors so the vehicle can read them (I use the Autel TS601)
6) Perform a TPMS Relearn sequence using DRB III Emulator. Chirp each wheel when requested by the emulator. (Takes about 5 minutes)
Turns out I have a couple of older laptops that have Windows 7 or XP installed. Gotta boot them up (& charge the batteries) to check them out.

Thanks
 
Last edited by dedwards0323; Aug 26, 2021 at 07:42 PM.
Reply
0