Originally Posted by
ku95
Hello,
There are epoxy grooves where bearings are located.
I think these epoxy is for thermal expansion of bearing or casting of S.C.
So It must not be melted because it should work.
Bearings could be pulled out with press machine and some handy tools without heating but it was not easy work.
Please refer to below pictures.
One important thing is that middle 2-bearings should be installed front face each other.
This forum owes you a debt of gratitude for the descriptions and photos of something SRT owners have but are fortunately not likely to see in pieces.
Thank you for the great photos they explain a lot.