Acquired leather seats with power and heat from Ebay. Apparently the power side installation is a snap, the heater will be more interesting. I also acquired the control fascia with seat heater rockers. Anyone experience this graft?

Thanks,
Gary
2006 Roadster

 

aww you ******* those where my heater buttons ... hehehe congrats on the win i forgot about the auction ending and went on too late ...

hope there is another set somewhere for me !

 

I apologize for the one-upmanship. Apparently there are enough Crossfires being demolished to meet our needs...The seat I acquired were stated to be mint...They are...LKQ Good company to do business with. Installation of the heater controls will be interesting... Waiting on my shop manual.

Thanks,
Gary

 

very kewl ... lemme know how it goes ... i am going to go pickup my set from LKQ tomorrow ... will post pics when i get them.

i was hoping the heater wiring was already there ... oh well we'll do without it then and just make our own.

oh btw you can download the entire shop manual in pdf format somewhere on these boards if i remember correctly.

 

To install the heater switch/module you'll need to remove the radio, so get the tool for that also.
I've installed the heater module, but I haven't wired it yet...two wires for power to the module and then one wire to each seat plus a ground.
You can get the wiring diagram here: http://homepage.mac.com/gregmeach/XFire/

 

Check your messages. I have decided not to use the heaters so switches and fascia available.