Crossfire Coupe A place to discuss Coupe specific topics.
Sponsored by:
Sponsored by: CARiD

Help accessing speaker

Thread Tools
 
Old Jul 21, 2006 | 06:35 AM
  #1 (permalink)  
DOC CC's Avatar
Thread Starter
Joined: Jan 2006
Posts: 23
Likes: 0
Question Help accessing speaker

I have noticed recently that my left speaker is squeaking especially when the bass is max. Never happened before. What is the easiest and neatest way of accessing the speaker and attached wires without damaging the chrome surround or the rest of the door panel?

Please help!!
 
Reply
Old Jul 21, 2006 | 11:18 AM
  #2 (permalink)  
BlackCrossFire6spd's Avatar
Joined: Mar 2006
Posts: 157
Likes: 1
From: Miami
Default Re: Help accessing speaker

To get to the speaker, you need to remove the door panel. I think you have to remove the speaker grille from behind the panel if i remember correctly. To remove the door panel, you have to remove the metal plate in the corner of the door using a very, very small torx bit. next, split the door handle in half where the line is using a plastic wedge on the bottom in the middle, this reveals 2 screws. then remove the SRS cover to reveal another screw. that should be all you need to do to get the panel off. Using a panel puller (local auto parts store) pry the lower corner from the door. You will hear a series of loud pops as the panel clips detach from the door. Once the lower section is free, lift upward, remove the door handle cable, disconnect all harnesses and you are good to go. Put it back on in the reverse order. Before you do all of this, I would try to figure out exactly what is making the noise. put pressure on the panel around and on the areas making noise, and if it continues to rattle, than I would say its time for new speakers.
 
Reply
Old Jul 21, 2006 | 04:03 PM
  #3 (permalink)  
ndfrspeed2's Avatar
Joined: Apr 2004
Posts: 36
Likes: 0
From: Wilmington, NC
Default Re: Help accessing speaker

I would disconnect the battery too. From other posts I've read about this you have to disconnect the battery and let the car sit for a bit so the system can discharge...something like that...prevents the airbag in the door from going off in your face.
 
Reply
Old Jul 21, 2006 | 06:45 PM
  #4 (permalink)  
Eracer76's Avatar
Joined: Apr 2006
Posts: 274
Likes: 0
From: Yorkville, IL
Default Re: Help accessing speaker

You do not have to disconnect the battery. The doors airbag does not come off with the door panel, it stays on the door and you don't even need to touch it.

I would do as BlackCrossFire said and put pressure on the door in areas around the speaker, tweeter, and handle...these door panels are terrible when it comes to squeaks and rattles with that aluminum looking trim pieces. It could very well be a squeak or rattle of the door that your hearing and not the speaker itself.

If you have to remove the door panel...
to add to BlackCrossFire's post, there is also a screw behind the trim piece around the tweeter/door opener, be careful removing this piece, it could break pretty easy if you don't know what your doing.
 

Last edited by Eracer76; Jul 21, 2006 at 07:00 PM.
Reply
Old Jul 21, 2006 | 08:11 PM
  #5 (permalink)  
BlackCrossFire6spd's Avatar
Joined: Mar 2006
Posts: 157
Likes: 1
From: Miami
Default Re: Help accessing speaker

you are right, there is a screw behind that thing, and yes, be very careful removing the panel. it is a very flimsy plastic.
 
Reply
Old Jul 24, 2006 | 05:41 AM
  #6 (permalink)  
DOC CC's Avatar
Thread Starter
Joined: Jan 2006
Posts: 23
Likes: 0
Default Re: Help accessing speaker

Thanks for all your replies. I really do appreciate it. I will keep in touch as to what happens when I open up the door. Let you know if I get smacked in the head with the air bag as well...
 
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
usprb1976
TSBs and How-To Articles
5
Apr 4, 2024 04:57 PM
blackpepper
Audio, Video and Electronics
63
Dec 18, 2021 06:17 PM
pioneer4x4
Audio, Video and Electronics
12
Mar 18, 2021 02:17 PM
PNA
All Crossfires
14
Nov 12, 2020 04:44 PM
RamblinShamblin
Crossfire Roadster
6
Aug 12, 2017 10:55 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 



All times are GMT -4. The time now is 12:35 PM.