Hey, is it possible to pop out the center of the Chrysler emblems on the front end, the back end under the spoiler, and the one on the steering wheel.

I want to replace those with the Autobot insignias from Transformers.

 

It doesn't pop out. You'll have to break it with a ball peen hammer or something.

 

how would I go about removing them?

 

Remove the emblem or the wing? Emblem you have to crack with screwdriver and/or hammer and chip away. You can try prying off with a small screwdriver but most likely will dent or chip the silver of the wing.

Wing on the rear is just held with adhesive tape. It has a hole in the middle that you can probably use to pop emblem off and get it off in one piece if you want to save the chrysler emblem.

 

Do you want to totally get rid of the Chrysler emblem, or just cover it
up with the Autobot insignia? I am sure there is somebody on this forum
that can make you a custom decal to place over the emblem.
Much like the custom badges already produced by our members here, you wouldn't be able to tell it was covering the original badge. Of course,
you would be limited to the shape of the current badge but I bet a black oval with the insignia imprinted on it in the correct shape should work.

 

...aw, forget it.

 

..........................

 

So, who should I contact?

 

https://www.crossfireforum.org/forum...ead.php?t=7332


https://www.crossfireforum.org/forum...97&postcount=1