its about time for me to start dropping $$$ into my SRT. i was wondering if anyone could recommend a shop around the ATL area. (willing to drive further for a trusted shop) looking to dyno and then have mods put on. have a long wish list so any info will be welcomed...thanks and again love the forum...

 

please anyone?

 

if any of the venders know of anyone that they trust it would be very helpful

 

Most mods on this car you can do yourself. Needswings intake is a very simple bolt on and so is the pulley's. DIY! At least you have peace of mind then. Dyno runs are good after all the bolt-on's. Most of these cars are putting 300-320 down on a dyno.

 

thanks for the reply...im thinking of the DIY route but was not sure of it...

 

just try to search imports in the area, thats what i did found a german feller local that will do mod's
euromot 865-988-9985

 

For the best do it yourself mod I'd get code3s SC pulley, 1 bolt and you get almost 40 hp.
I know my SRT6 is the only one that has had it !pm me if you need more. Or email.

 

UncleO!

Where do you take your xFire for warranty work? I'll be at Carl Gregory tomorrow morning at 8:00 sharp for some minor free stuff. PM me and we can meet if you don't mind driving over?

See ya',
Max

 

If you want a great shop in the ATL area go to Benzwerks. They are out in Roswell near Andretti Speed Lab.

They will install anything you want or do custom work. The work is top notch.

 

thx...i will check them out. want to dyno before and after...

 

Dynolab does a good job. They have a dynojet.