Does anyone know the rolling radius of the rears? I'm trying to crunch some numbers, and cant find it. Either my info or math is bad. If anyone knows or could measure it would be greatly appreciated.
thanks

 

I think it's 26" and about 800 revolutions a mile.

 

Ok, im running the math on the SRT 6.

So far....

Drive wheel torque = 2908.187,

Wheel thrust = 2692.737 ?

I need an accurate rolling radius measurement for accurate #s, And all other equations rely on these base numbers.

I tend to do insane research, and I am trying to plan a build from iraq, (royal pain)
any help here would be great.

 

Deleted, NIPR flashed.

 

What do mean by the rolling radius? how many revolutions per mile?

 

Looking at your calculations, I think maybe you mean gear ratio, I believe it is 3:07-1 on the srt6. Hope that helps and be safe over there and thanks for serving

 

The rolling radius is the vertical measurement from the center of the wheel to the tire's point of contact on the ground. I have to equate for the weight of the vehicle as it slightly compresses and flattens the tire on the contact patch. Its a minimal value, but its pertanent in the equations.

 

You lost me! Have fun.

 

Wouldn't it be dfferent depending on the tire.

 

I have the ratios, I just need to confirm my numbers on the wheel thrust. Do the numbers look accurate to you? Been working 18 hours and my minds not as sharp as it should be. Right now coffee equals conciousness.

 

I'm basing all equations on factory specs.

 

25" top to bottom, so 12.5" is what you are looking at roughly, thanks for your service...by the way, Doc

 

Thank you Doc, an I'm proud to serve. i will post all my numbers once ive finished.